Overview Block Weather station display

This control element shows the values of a weather station at a glance: the outdoor temperature, a symbol for the weather situation and up to six further values, for example wind, brightness or air pressure. It is for display only. If the weather station is also to control wind, rain and frost alarms or the shading, the control element Block Weather station is the better choice.

Operation

Weather station display on the page
  1. Weather situation: the state in words, matching the symbol.
  2. Temperature: large with one decimal place, the unit small next to it.
  3. Weather symbol: is chosen as follows:
  4. Further values: up to six values with their names, in the form set by the installer. Values that are not assigned are left out; the others move up.

The element has no dialog – tapping it does nothing.



Setup

This section is meant for the installer of the system.

The addresses are linked directly at the control element, no function block is needed. The values come for example from a weather station on the bus or from the function block Weather station. The control element is wider than it is high; its size can be set freely. Symbol, text and spacing grow along with it, so the layout looks the same at any size.

Parameters

Display

Cloudy below Brightness in lux below which “Cloudy” is shown; from this value on “Sunny” applies. Default 5000 lux.
Values Opens the list of further values. + and – add or remove a value (six at most), the arrows move it; the values are shown on the tile in the same order. Per value:
  • Name – shown on the tile to the left of the value and used as the name in the address links, e.g. “Wind”. Empty: the tile shows only the value, the address is called Value 1, Value 2, …
  • Formatting – presentation of the value, right-aligned, e.g. %.1f km/h. See Format.
The linked address moves along with the value, a removed value loses it. Default is three values with %.1f kmh, %d Lux and %.1f Pa.

Address links

Temperature Outdoor temperature in °C. If it is below 1 °C while it rains, snow is shown. Not linked: 0 is shown.
Brightness Brightness in lux. Below “Cloudy below” Cloudy is shown, otherwise Sunny. Not linked: the brightness counts as 0, so Cloudy is always shown.
Rain Optional. Rain message: not equal to 0 means rain (or snow), 0 dry. Not linked: no rain is shown.
Value 1 to Value 6 Optional. One address per value created; it carries the name from the list of values. Presented with the respective formatting. Not linked: the line is left out.

See also General properties of all control elements.