Overview Shelly 0-10V Dimmer

The function block connects the Shelly Plus 0-10V Dimmer and the Shelly Dimmer 0/1-10V PM Gen3. Both control an LED driver or a ballast via a 0-10V output. The block switches the light on and off, sets the brightness in percent and reports the state as well as the two push-buttons or switches connected to the device. The Gen3 version also measures power and consumption.

Whether the device works with 0-10V or 1-10V, the minimum brightness and the behaviour after a power failure are set in the web interface of the device. The block does not change these settings.

The Shelly Dimmer 0/1-10V PM Gen3 has to be calibrated in the web interface after commissioning. Until then the device does not accept a brightness, it can only be switched on and off.

Inputs

LB On/off Switches the light on (1) and off (0). When switching on, the device uses the last brightness.
LP Percent Brightness in percent from 0 to 100. A value greater than 0 switches the light on with this brightness, 0 switches it off. The value is sent to the device on every change and also when the same value is written again.

Outputs

SB Status on/off Feedback whether the light is switched on.
SP Status percent Feedback of the set brightness in percent.
S1 Status switch 1 State of the push-button or switch 1 connected to the device. A push-button reports 1 as long as it is pressed.
S2 Status switch 2 State of the push-button or switch 2 connected to the device.
P1 Power W Current power in watts. Only with the Shelly Dimmer 0/1-10V PM Gen3; with the Shelly Plus 0-10V Dimmer the output does not change.
W1 Consumption Wh Meter reading of the consumption in watt hours. Only with the Shelly Dimmer 0/1-10V PM Gen3.
AI Addon analogue input Voltage at the analogue input of the addon. Only present when the addon is enabled.
DI Addon digital input State of the digital input of the addon. Only present when the addon is enabled.
T1 Addon temperature 1 Temperature of the first DS18B20 sensor, or of the DHT22 if that one is selected. Only present when the addon is enabled.
T2 Addon temperature 2 Temperature of the second DS18B20 sensor. Only with the setting "+Addon DS18B20".
T3 Addon temperature 3 Temperature of the third DS18B20 sensor. Only with the setting "+Addon DS18B20".
F1 Addon humidity in % Relative humidity of the DHT22 sensor. Only with the setting "+Addon DHT22"; the output then takes the place of T2.

Parameters


MQTT topic Topic of the device, exactly as in the MQTT settings of the device. Example: shellyplus010v-AABBCCDDEEFF

Addon Evaluation of the optional Shelly addon. None hides the additional outputs. +Addon DS18B20 shows three temperature outputs, +Addon DHT22 one temperature and one humidity output.
For the feedback to arrive, all three MQTT options must be enabled in the device, as described under MQTT devices - general. Without Generic status update over MQTT the outputs for status, power and consumption do not change.

In addition to the outputs listed, the command generate addresses creates an address named timeout. It is set to 1 when the device has not sent a message for a longer period of time.

See also MQTT devices - general.
See also general parameters of all function blocks.