Netatmo weather station| Delivers the measured values of a Netatmo weather station: base station (indoor), outdoor
module, wind gauge and rain gauge. One block per station; the base station is selected, the modules
belong to it automatically. An additional indoor module is added with the block
Netatmo indoor climate. The values come through the block Netatmo account. Netatmo only renews them every 10 minutes. If a module is missing, its output stays at 0. |
Outputs |
||
| TI |
Indoor temperature |
Temperature at the base station in °C. |
| FI |
Indoor humidity |
Relative humidity at the base station in %. |
| CO |
CO₂ ppm |
CO₂ level at the base station in ppm. |
| LA |
Noise dB |
Noise level at the base station in dB. |
| LD |
Air pressure hPa |
Air pressure at sea level in hPa. |
| TA |
Outdoor temperature |
Temperature at the outdoor module in °C. |
| FA |
Outdoor humidity |
Relative humidity at the outdoor module in %. |
| WS |
Wind speed km/h |
Average wind speed in km/h. |
| WR |
Wind direction ° |
Wind direction in degrees (0 = north, 90 = east). |
| WB |
Gust km/h |
Strongest gust in km/h. |
| RE |
Rain mm |
Rain of the last measurement in mm. |
| R1 |
Rain last hour mm |
Rain during the last hour in mm. |
| RT |
Rain 24 hours mm |
Rain during the last 24 hours in mm. |
| BA |
Battery low |
1 = the battery of at least one module is below 20 %. |
| ER |
Reachable |
1 = base station and all modules are reachable, 0 = Netatmo reports at least one as unreachable. |
| DA |
Data current |
1 = Netatmo renewed the values within the timeout. 0 = no data since start, account not signed in or timeout expired. |
Parameters |
||
| Account |
Optional. The Netatmo account block used to query this device. The selection is only shown when the project contains several accounts. Not set: the first account in the project. |
|
| Select device |
Opens the list of devices the account found at Netatmo, filtered to the devices that fit this block. The selection sets device name and device ID. The Studio must be connected to the controller and the account signed in. |
|
| Device name |
Name of the device at Netatmo, for display only. |
|
| Device ID |
Netatmo identifier of the device, room or home. Can also be entered manually. Empty: the block delivers no values and shows »Device?«. |
|
| Timeout data outdated |
If no new data arrives from Netatmo within this time (minutes), »Data current« drops to 0. The other outputs keep their last known value. 0 = never outdated. Default 30 min. |
|