Overview Jablotron alarm system



With this function block a Jablotron alarm system is connected via the RS485 interface.

Set the parameters Number of areas, detectors, PG outputs as they are programmed at the system and generate the variables. The system is then controlled via the addresses S/TS/US = 0=Armed, 1=Partially armed, 2 = Disarmed, feedback via "Status S/TS/US", PG outputs control via PG / Status PG.

Important — disarming belongs at the panel: Disarming via the visualisation or the APP is not recommended. An intrusion alarm system should only ever be disarmed at the panel itself — at the keypad, with a key switch or a code. Otherwise anyone with access to the APP can lift the intrusion protection; a lost or unlocked mobile device is then enough. Depending on the insurance policy and local regulations, operating it this way may also not be permitted.

It is therefore recommended to use the addresses for display only, and at most for arming. The safest approach is to withdraw the right to disarm from the user used for the connection, in the user profile of the panel — the panel then rejects the command itself, regardless of what the visualisation is configured to do.

Important: If the alarm system is nevertheless operated via the APP, special protective measures should be taken. For example, the setup of a private VPN access. Under no circumstances should the system be freely accessible from the Internet, e.g. via port forwarding.



Outputs
ER
 Error counter
 Number of communication errors

Parameters
Interface
 Type of interface:
  • Onboard: Built-in RS485 interface
  • USB: USB RS485 converter
  • Manual: Manual entry of the interface for diagnostics.
User
 User name
Password
 Password
Number of areas
 Number of areas
Number of PG outputs Number of PG outputs
Number of detectors Number of detectors

See also common parameters of all function blocks.